Murata LBCA1HN2EG-917- Unboxing | DigiKey

We take a look at the Type2EG EVK from Murata. This kit simplifies the evaluation, testing, and development of applications for software, hardware, and system engineers using the Type2EG BLE module.

Share

Video Player is loading.

Play Video

PlaySkip BackwardSkip Forward

Mute

Current Time 0:00

/

Duration 0:00

Loaded: 0%

0:00

Stream Type LIVE

Seek to live, currently behind liveLIVE

Remaining Time -0:00

 

1x

Playback Rate

• 2x
• 1.75x
• 1.5x
• 1.25x
• 1x, selected
• 0.75x
• 0.5x

Chapters

• Chapters

Descriptions

• descriptions off, selected

Subtitles

• subtitles settings, opens subtitles settings dialog
• subtitles off, selected

Audio Track

Quality Levels

Picture-in-PictureFullscreen

This is a modal window.

Beginning of dialog window. Escape will cancel and close the window.

Text

ColorWhiteBlackRedGreenBlueYellowMagentaCyanOpacityOpaqueSemi-Transparent

Text Background

ColorBlackWhiteRedGreenBlueYellowMagentaCyanOpacityOpaqueSemi-TransparentTransparent

Caption Area Background

ColorBlackWhiteRedGreenBlueYellowMagentaCyanOpacityTransparentSemi-TransparentOpaque

Font Size

50%75%100%125%150%175%200%300%400%

Text Edge Style

NoneRaisedDepressedUniformDrop shadow

Font Family

Proportional Sans-SerifMonospace Sans-SerifProportional SerifMonospace SerifCasualScriptSmall Caps

ResetDone

Close Modal Dialog

End of dialog window.

Close Modal Dialog

This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.

Close Modal Dialog

This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.

Murata LBCA1HN2EG-917- Unboxing | DigiKey

Inside the box, you’ll find the Type2EG evaluation board, a quick start guide, and a USB cable. The Type2EG BLE module features Bluetooth 5.2 with an onboard antenna and multiple interfaces. The evaluation board features automatic power supply switching with an on board regulator for switching between USB and the 3 volt battery, a header for external power supplies, an 8 pin DIP switch for UART communication and external device isolation, and multiple general purpose IOs. In this demo, we’ll follow the setup procedure for obtaining accurate power measurements. First, move all switches on the DEBUG-EN switch to OFF and connect the USB cable to your evaluation board and PC. The D23 LED will begin blinking. Press the SW1 button to stop blinking, and press again to resume blinking. Remove the shorting jumper from the VBAT—SEL header, and the D23 LED will stop blinking. Now connect an ammeter in series across the VOUT and VBAT pins on the VBAT—SEL header to measure current.